XW-110™ Installation for Walk-in Freezers

In this video you will learn how to physically install the XW-110 Wireless Temperature Sensor with an external temperature sensor to wirelessly monitor a walk-in freezer.

View the XW-110 Installation & Setup Guide for Walk-in Freezers  (0.3 MB)

How to install an XW-110 to monitor a walk-in freezer

Step 1: Drill a hole in the freezer

Remember to drill through the insulation

Step 2: Install the sensor

1. Thread the wire through the hole
2. Seal the interior hole using a non-hardening duct seal
3. Place sensor away from corners, vents, or doors (place in an area that best represents the freezer)
4. Also, seal the exterior hole using a non-hardening duct seal

Step 3: Wire the external sensor to the XW-110

1. First, remove the built-in temperature sensor
2. Then, wire the external sensor to the XW-110

Step 4: Mount and power the XW-110

1. Mount the XW-110 using mounting screws or an adhesive.
2. Power using the 5V power supply and/or batteries

Step 5: Clean up your wires

You are now ready to set up the XW-110 on your network

XW-110 Setup Using DHCP & High/Low Email Alerts
In this video you will learn how to access the XW-110’s setup pages, how to set it up on a network using DHCP, and how to configure it to send email alerts if the temperature exceeds a certain threshold.